High Pass and Low Pass Filters - Chris Scott and Associates


High Pass & Low Pass Filters (optimized design - see actual performance below)
10 Megahertz Low Pass Filter Compact cylindrical BNC design - ORDERING
This 10 Mhz low-pass filter is designed to prevent spectrum analyzer overload and intermodulation when conducting AM broadcast station measurements in the presence of strong FM band energy. This product is offered separately, or as an LP-3 loop antenna accessory.	Actual two-port measured performance: 10-30 MHz 10-200 MHz

Specifications Cutoff Frequency 10 MHz Impedance: 50 ohms Connectors: BNC Maximum VSWR < 8 Mhz 1.6:1 Maximum attenuation < 8 Mhz: .5 dB Maximum operating level: +20 dBm Minimum Attenuation > 15 Mhz: 30 dB Construction: Plated brass.

175 Megahertz High Pass Filter Compact cylindrical BNC design - ORDERING
This 175 Mhz high pass filter is designed to prevent spectrum analyzer overload and intermodulation when measuring FM harmonic levels, either when connected to a standard dipole antenna, or when connected directly to a transmitter sample port.	Actual two-port measured performance: 100-200 MHz 90-500 MHz 50-2000 MHz

Specifications Cutoff Frequency 175 MHz Impedance: 50 ohms Connectors: BNC Maximum VSWR > 175 Mhz 1.6:1 Maximum attenuation 175-400: 1 dB Maximum operating level: +20 dBm Minimum Attenuation at highest fm channel: 31 dB Construction: Plated brass
Partial listing of clients and customers
Specifications and pricing subject to change GoTo cs&a Main Page

Specifications

Specifications